Nano Fuel Saver uses both the latest nanotechnology and the principle of FIR to make your driving experience extraordinary. After installation, it absorbs the heat energy from engine to lead out FIR thermal energy to minify fuel’s molecules, purify impurities contained in the fuel, advance atomization effect, enhance complete combustion, increase horsepower and torque, improve fuel economy, reduce engine vibration, faster acceleration, cut down fuel consumption, reduce engine carbon build-up, reduce toxic exhaust emissions to diminish air pollution, keep the engine in optimum condition to extend its lifetime, easy installation, no engine refit, and no chemical additive.

In layman’s terms the Nano FuelSaver is a tube impregnated with nano-particles. When this tube gets heated up, it creates a wave called Far Infrared Ray (FIR). FIR is a part of the invisible light spectrum and it is in between visible light and microwave but not harmful to the human at all. In fact scientists call it the 'light of life'.

This ray has a major effect on the petrol and diesel by resonating the fuel molecules in the fuel and preventing clustering of the hydrocarbons. Also this resonance makes the fuel molecules to be smaller. This is really like pumping high octane fuel into your car (i.e. super petrol/diesel). This allows the fuel and air to be mixed more evenly and efficiently before it is delivered into the engine for combustion.

The overall result is more complete combustion. More of the fuel is used for powering the car, and less is lost as harmful emissions as carbon monoxide.

 

 
 
Find the fuel line from the fuel tank to the engine. Wrap the FuelSaver tightly around the fuel line. (If there is any extra cover, please remove the cover before installing the FuelSaver.
If the FuelSaver is longer than the fuel line, cut the FuelSaver into suitable length. Try to use the FuelSaver on other portion on the fuel pipe to achieve the best outcome.
If the wall of the fuel pipe is too thick, or if the fuel pipe is rubber, we would suggest wrapping a layer of aluminum foil before the installation.
Clean or replace the air filter of your car while you doing the installation.
If the idle speed is too high after installation, this should be adjusted.
PETROL ENGINE: Suggest installing one FuelSaver for engines below 4 cylinders; installing 2 pieces for engine 6 cylinders and above.
DIESEL ENGINES: Suggest installing two FuelSavers for at least for 4, 6, and 8 cylinders.
IDo not spray the FuelSaver with any chemicals (Please cover the FuelSaver before you spray any chemicals or engine cleaning liquids).
Find the fuel line going to the engine. Install the FuelSaver as close to the engine as possible by wrapping the FuelSaver tightly around the fuel pipe to get the maximum results.
  FuelSavers could be installed on the Diesel Fuel Line as well as on the injection lines as close to the engine as possible by wrapping the FuelSavers tightly around the fuel pipe.
The Nano Fuel Saver is a tube of rubber impregnated with nano-particles of a mineral ore selected for it Far Infra-Red (FIR) characteristics. FIR is part of the invisible light spectrum associated with heat.

Exposure to these nano-particles has a major effect on petrol and diesel, by realigning the molecules in the fuel and preventing clustering of the hydrocarbons. This realignment allows the fuel and air to be mixed more evenly and efficiently before it is delivered into the engine for combustion. The particles also transmit heat from the engine through to the fuel line, which warms the fuel slightly prior to combustion. The result overall is that the combustion is more complete. More of the fuel is used for powering the car, and less is lost as harmful emissions.

 

Copyright © 2004 NANO TECHNOLOGY LTD. All Rights Reserved.
Concept and Design by
XEBA LIMITED .